Ok, for you guys who know this stuff:
My snowblower started stalling & then not starting. After priming it, it would turn over, but then stall. Fresh gas, with Sea foam...gas valve/peacock is open.
I'm guessing it's a carb problem. Most likely something gummed up from the ethanol crap.
The last time I rebuilt a carb was 1982 & I really don't want to take it all the way apart...I'll probably mess it up worse.
My questions is...how far do i have to go to get it to run?
Here are a couple of youtube videos with the same engine I have (a Tecumseh LH195SA/LH195SP). The snowblower is an Ariens #932038-5520 2 stage.
My snowblower started stalling & then not starting. After priming it, it would turn over, but then stall. Fresh gas, with Sea foam...gas valve/peacock is open.
I'm guessing it's a carb problem. Most likely something gummed up from the ethanol crap.
The last time I rebuilt a carb was 1982 & I really don't want to take it all the way apart...I'll probably mess it up worse.
My questions is...how far do i have to go to get it to run?
Here are a couple of youtube videos with the same engine I have (a Tecumseh LH195SA/LH195SP). The snowblower is an Ariens #932038-5520 2 stage.
If Sonny had EZ-Pass, he'd have survived that hit...
Never apologize mister, it's a sign of weakness. - Capt. Nathan Cutting Brittles
Never apologize mister, it's a sign of weakness. - Capt. Nathan Cutting Brittles